> If you are using a tap device, you need further steps to achieve > either two real network-interfaces or you bridge to a virtual tap-device. > If you want to reach your "server" through the VPN, you need client to client, vpn server to other ip (not clients) on the subnet, client to any ip different from the vpn server. Every other ping combination on the subnet works fine. Only with the vpn server address and the clients. ![]() ![]() Unfortunately i've already tried this, but there is nothing to trace because there is no gateway involved, everything is on the same subnet.Īnyway, from vpn server (192.168.2.45) to client (192.168.2.240) the output is > the packet reach the target but the ACK dont know how to come back yo you. > tcpdump on the side you are not receiving the ping because it is possible > If yes, maybe the returning ACK is not well configured, in that case, try > Run traceroute and check if it follows the right path TX packets:6013 errors:0 dropped:0 overruns:0 carrier:0 RX packets:6013 errors:0 dropped:0 overruns:0 frame:0 TX packets:1875849 errors:0 dropped:0 overruns:0 carrier:0 RX packets:1755617 errors:0 dropped:0 overruns:0 frame:0 UP BROADCAST RUNNING PROMISC MULTICAST MTU:1500 Metric:1 Pinging 192.168.2.45 with 32 bytes of data:Īny other IP 192.168.2.x has no problems with clients, and the vpn server ha problem only with ping to clients, other ip of the subnet Ping 192.168.2.240 (which is a connected client) returns When a clients connect, it is assigned an IP address from the DHCP server from the clients i can access almost all the 192.168.2.0 addresses and viceversa.īut i can't ping/access the vpn server IP (192.168.2.45), and i can't pings clients from the vpn server. There is a dhcp server on the 192.168.2.0 subnet that serves from 192.168.2.201 to. The virtual hub, "Bridge with Phisycal Existing Network adapter", and the eth0 network adapter. I have configured a single virtual hub, and via "Local Bridge settings" i created a bridge on that Hub selecting ![]() I have one private IP address assigned to the only network interface present (eth0:192.168.2.45). Of SoftEther installed, running as a service as root. I have a Lubuntu 12.04 32 bit server with this version Hello everyone, i have a problem i can't figure out.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |